Phantom Quadrant presents:

Note the pin. Very important. Behind that pin, at about 2 1/2″ from the bottom (anywhere around there), is a small, 4″ hole that you’re going to put a larger bolt in. When you’re done, this will hold the large ball in the end of the tube.

4) Put the new braided sleeve on. Loosen the long bolt on the old tube. The large bolt is probably the biggest one. It’s in there too. Notice the front wing tube. The tip is further back from the “butt” than it should be. Look at where the end of the piece should go. This will be the end of the wing tube. Test it to see if it will fit inside the